Instruction manual

Audio/Video Configuration

Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide

System Settings

FIG. 62 displays the System page. The System page allows you to switch any audio or video input to any output, save

your DVX settings, and load your DVX settings for later reuse, set the front panel button lockout, adjust front panel LED

and LCD intensity, and view the device information for the switcher.

FIG. 62 WebConsole Configuration page - System page

1 - Input/Output Matrix: Select an option button under each output to switch video or audio from the

corresponding input to that particular output. Green text indicates a signal is detected, gray indicates a signal is

detected but cannot be identified, and red indicates no signal is detected. You can only select one video and

audio input at a time per output. Select None if you do not want any video or audio on the selected output.

2 - Save/Load: Click the buttons to save or load your DVX settings. Files are saved as a .xdv file to any local or

network drive of your specification.

Note: Due to the way many browsers manage file upload requests while in an authenticated session, it is not

possible to load a DVX setup (.xdv) file with any web browser AMX has tested, except Microsoft Internet

Explorer when HTTP Security is enabled on the DVX Master.

3 - Microphone Mode: Click the checkboxes to activate or deactivate the microphones connected to Mic

Inputs 1 and 2 when in Dual Mode, or the L/R Microphone when in Single Stereo Mode.

4 - Front Panel Lockout Mode: Click the check box to activate a lockout of some or all of the buttons on the

front panel. Select the type of lockout in the Lockout Mode section. Select Full Lockout if you want the lockout

to block the use of all front panel buttons. Select Menu-only Lockout if you want the lockout to only block the

use of the menu options on the front panel. The Switch, Take, Status, Volume, and Mute buttons are still

available with this option.

5 - Front Panel Backlight: Use the sliders to adjust the backlight intensity of the LCD display and the LEDs on

front panel buttons. You can set the backlight intensity for each option between 0 and 100. The default setting

for each option is 50.

6 - DXLink Ethernet: Use the menu to select the DXlink Input or the DXLink Output, then click the Auto check

box to enter Auto mode for the selected input or output. In Auto mode, Ethernet traffic is enabled if the port is

connected to an end-point transmitter or receiver, but is automatically disabled if connected to a port on

another Enova DVX or DGX. When Auto is not checked, Ethernet is turned off for the selected port.