Instruction manual

Audio/Video Configuration
57
Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide
The following table lists the general options for the WebConsole Configuration page:
Video Settings
The Video Out tab enables you to set the resolution, aspect ratio, and picture qualities of each individual video output.
Any changes you make are processed immediately on your source input and output devices.
Video Out
FIG. 58 displays the Video Out page for the DVX.
General Options
Mute Turns off the audio for the device.
Amp Volume Sets the output volume.
Refresh Click to reload all settings.
Reset to Defaults Click to reset the current page’s settings to its factory default.
Video tab Click this tab to access the video settings for the device. See the Video
Settings section on page 57 for more information.
Audio tab Click this tab to access the audio settings for the device. See the Audio
Settings section on page 61 for more information.
System tab Click this tab to access the system settings for the device. See the System
Settings section on page 67 for more information.
FIG. 58
WebConsole Configuration page - Video Out tab
4
1
2
3
7
5
4
6
7
8
9
10
11
1 - Output Select: Select the corresponding option button to select the video output to adjust. When you select
an output, the other options on the page change to reflect the output’s current settings. You can copy the
settings from one output to the selected output by using the Copy From menu.
Note: If you have a Virtual device using the same port (5002) as the DVX, all notifications are routed to virtual
device rather than the DVX. In this case, initial states for the video outputs will not be represented in the Web
Console. When possible, avoid using virtual devices on the same port as the DVX.
2 - Blank Color/Logo: Use the drop-down menu to select the color of the blank screen on the output. If you
have uploaded a logo to display on the output, you can also select the logo from this menu.