Instruction manual

Wiring and Device Connections
18
Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide
Rear Panel Video Inputs and Outputs
The following sub-sections describe each component on the rear panel of the DVX. All digital inputs and outputs on the
DVX support HDCP. Refer to FIG. 4 on page 8 for the component layout of the rear panel.
MULTI-FORMAT VIDEO INPUTS (1-2)
The two MULTI-FORMAT VIDEO INPUT connectors on the rear panel are used to connect video source input devices
to the DVX (FIG. 29). The DVX routes video from connected source input devices to the connected output devices.
These numbered inputs correspond to the input port number of the video signal when making a switch or adjusting video
input parameters.
The following table describes the pinout configuration of the MULTI-FORMAT VIDEO INPUT connectors:
FIG. 29 MULTI-FORMAT VIDEO INPUTS (DVI-I connectors)
The MULTI-FORMAT VIDEO INPUT connectors on the DVX are DVI-I (integrated
digital/analog) connectors. These connectors support both DVI-A (analog) and DVI-D
(digital) inputs.
MULTI-FORMAT VIDEO INPUT Connectors - Pinouts and Signals
Pin Signal Pin Signal Pin Signal
1 TMDS Data2- 9 TMDS Data1- 17 TMDS Data0-
2 TMDS Data2+ 10 TMDS Data1+ 18 TMDS Data0+
3 TMDS Data2/4 Shield 11 TMDS Data1/3 Shield 19 TMDS Data0/5 Shield
4 n/c 12 n/c 20 n/c
5 n/c 13 n/c 21 n/c
6 DDC Clock [SCL] 14 +5 V Power 22 TMDS Clock Shield
7 DDC Data [SDA] 15 Ground (for +5 V) 23 TMDS Clock +
8 Analog vertical sync 16 Hot Plug Detect 24 TMDS Clock -
C1 Analog Red
C2 Analog Green
C3 Analog Blue
C4 Analog Horizontal Sync
C5 Analog Ground
If a DVI source is attached before setting the input to DVI, you may need to reboot
the source for it to recognize the DVI input description information required by the
DVI standard.