Instruction manual

Wiring and Device Connections
11
Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide
AUDIO MENU Pushbutton
Press the AUDIO MENU pushbutton (FIG. 12) to access the audio options, displayed on the LCD display. There are
three audio menus (AUDIO OUTPUT, AUDIO INPUT, and MIC) and all are accessible by using this button. Multiple
presses cycle through the various AUDIO menus.
The Audio menu enables you to see and adjust most parameters of the audio input and output signals.
Use the UP and DOWN navigational buttons to traverse the various parameters.
Use the LEFT and RIGHT navigational buttons to adjust the selected audio parameter.
Adjustments take effect immediately and are saved when you advance to another option or exit the menu. The menu
exits automatically after no user interaction on the front panel for 30 seconds.
See the Audio Settings section on page 49 for a listing of all available options and instructions on how to change the
settings.
Navigation Pushbuttons
The four directional navigation buttons (Left/Right/Up/Down) enable you to navigate through and adjust the
configurable parameters shown on the LCD display. The UP and DOWN navigation buttons are used to move between
configurable parameters within a menu. Pressing UP takes you to the previous configuration parameter. Pressing DOWN
takes you to the next configuration parameter. These buttons do not change the currently selected menu.
The LEFT and RIGHT navigation buttons are used to change the setting of the displayed parameter. If the parameter is
read-only the value cannot change. Pressing LEFT decreases the value displayed if the setting is numeric, or goes to the
previously set item if the setting is a set selection. Pressing RIGHT increases the value displayed if the setting is
numeric, or goes to the next set item if the setting is a set selection. These buttons do not change the currently selected
menu.
FIG. 12 AUDIO MENU button
FIG. 13 Navigation buttons
Move up to previous configuration parameter
Move down to next configuration parameter
Increase value, or change the
state of the selected parameter
Decrease value, or change the
state of the selected parameter