Instruction manual

Overview
3
Enova DVX-2150HD/2155HD All-in-One Presentation Switcher Operation/Reference Guide
DVX-2150HD/DVX-2155HD/DVX-2110HD Specifications (Cont.)
MIC INPUTS: 2 3.5mm 3-pin captive-wire connectors receive up to 2 mono microphones (balanced or
unbalanced audio and switchable Phantom Power). See the MIC INPUTS (1-2) section on
page 15 for more information.
AMP OUT: • AMP: 4-position captive wire connector provides amplified audio output with volume
control (-SP models only).
• AMP: Two 2-position captive wire connectors provide 70V or 100V mono amplified
audio output (-T models only).
See the AMP OUT section on page 16 for more information.
AUDIO OUTPUTS: 2 3.5mm 5-pin captive-wire connector provides for balanced or unbalanced, mono or
stereo line-level audio output. See the AUDIO OUTPUTS section on page 17 for more
information.
S/PDIF OUTPUT: 1 Coaxial RCA connector provides digital S/PDIF audio output that can mirror any of the 3
analog audio outputs, 2 HDMI outputs, or DXLink output.
MULTI FORMAT
VIDEO INPUTS:
2 DVI-I input connectors provide analog and digital video inputs for up to two video
sources.
Each MULTI FORMAT VIDEO INPUT connector supports VGA, S-Video, composite video,
component video, DVI, or HDMI video input. See the Available Pixel Display and Refresh
Rates section on page 117 for information on supported video formats and resolutions.
See the Cable Details and Pinout Information section on page 33 for information about
wiring conversion cables.
HDMI INPUTS: • 4 HDMI inputs (3-6) receive digital audio and video from up to four video sources.
(DVX-2150HD only)
• 2 HDMI inputs (3-4) receive digital audio and video from up to two video sources.
(DVX-2155HD and DVX-2110HD only)
All HDMI inputs are HDCP compatible. See the HDMI INPUTS (3-6) section on page 20
for more information.
DXLINK INPUTS 2 RJ-45 inputs (5-6) provide support for digital video, audio, Ethernet, bi-directional control
and power over Category Cable from any DXLink transmitter. (DVX-2155HD only). See
the DXLink INPUTS (5-6) section on page 21 for more information.
VIDEO OUTPUTS: • 2 HDMI Output connectors (1-2) each provide HDMI digital audio and video output.
• 1 DXLink RJ-45 output (3) provides digital video, audio, Ethernet, and bi-directional
control over Twisted Pair Cable to DXLink Receivers. (On the DVX-2110HD, the DXLink
output mirrors HDMI port 1.)
See the VIDEO OUTPUTS (1-3) section on page 22 for more information and important
cable recommendations.
CONFIG DIP Switch: 8-position Master configuration DIP switch allows setting the Serial Programming port
baud rate and onboard Master execution mode (PRD or normal). See the CONFIG DIP
Switch section on page 27 for more information.
PROGRAM Port: DB9 connector (male) connects to a DB9 serial port on a PC, for serial communication.
This connection is used to configure system settings.
Note: This port is not recommended for firmware updates or large file transfers. Any large
data-intensive operations are better handled via Ethernet.
See the PROGRAM Port section on page 28 for more information.
ID Pushbutton: Black ID pushbutton sets the NetLinx Device ID assignments of the Internal Control
Device. See the ID Pushbutton section on page 29 for more information.
LAN Port: RJ-45 connector provides TCP/IP communication. See the LAN (RJ-45) section on
page 29 for more information.