Viewpoint Widescreen Touch Panels Operation/Reference Guide

Setup Pages

MVP-5100/5150 Modero Viewpoint Touch Panels

Setup Page (Cont.)

Connection Status: Displays whether the panel has external communication, as well as the

encryption status of the Master, the connection type (Ethernet or USB), and to

which System the panel is connected.

• Until a connection is established, the message displayed is: “Attempting via

Ethernet” or "Attempting via USB".

• When a connection is established, the message displayed is either: “Connected

via Ethernet “or “Connected via USB “.

• The word “Encrypted” appears when an encrypted connection is established with

a NetLinx Master.

Note: The panel must be rebooted before incorporating any panel communication

changes and to detect Ethernet connections.

Display Timeout: Indicates the length of time that the panel can remain idle before activating Asleep

mode, causing the device to power down.

• Press the Up/Down buttons to increase/decrease the Display Timeout setting in

5-second increments. Range = 0 seconds to 2 hours.

• Set the timeout value to 0 to disable Sleep mode.

Note: Small timeout values maximize the life of the battery charge.

Disable Timeout on External Power: Pressing this button prevents the panel

from entering Sleep mode and powering down if it is connected to an external

power source, such as a Table or Wall-Mounted Docking Station.

Inactivity Page Flip

Timeout:

Indicates the length of time that the panel can remain idle before automatically

flipping to a pre-selected page.

• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip

Timeout setting. Range = 0 - 240 (minutes).

• Set the timeout value to 0 to disable Inactivity Page Flip mode.

Note: The touch panel page used for the Inactivity page flip is named within a

small Inactivity Page field below the buttons.

Panel Brightness: Sets the display brightness levels of the panel.

• Press the Brightness Up/Down buttons to adjust the brightness level.

Range = 0 - 100.

NOTE: Be careful not to turn down the brightness too low to be able to see the

Setup page.