Corporation Remote Keypad Device Operation/Reference Guide

Programming The Attaché
9
Mio Attaché Remote Keypad Device
Programming The Attaché
KeypadBuilder
Most functionality of the Mio Attaché is handled using the application, KeypadBuilder. Go to www.amx.com
for the KeypadBuilder Instruction Manual.
Using Connector Ports on The Attaché
The programming jack is used for communication between the device and KeypadBuilder. The programming
jack uses a three-wire, 2.5 mm stereo jack, you can order the programming cable (FG10-817) from AMX if
you do not currently possess one. The baud rate is 115200.
To download KeypadBuilder Configuration Files:
1. Extend the kickstand on the Mio Attaché to the upright position, exposing two screws on the battery door.
Remove the two screws holding the battery door in place, exposing the programming port within the
battery compartment, 2.5 mm stereo female conductor jack.
2. Connect the 2.5 mm stereo plug (male) end of the programming cable (FG10-817) into the programming
port shown in FIG. 4.
3. If necessary, connect the DB-9 end of the programming cable to the female DB-9 connector on the DB-9
extension cable (FG10-727).
4. Connect the female DB-9 terminal end of the extension cable to the port on the back of your computer.
5. Configure the communication parameters in KeypadBuilder.
FIG. 4 Connecting The Keypad Device to Your PC
Stereo plug male
DB-9 connector
Cable FG10-817 to cable FG10-727
to PC
programming
cable
Keypad device
Programming
jack
Power
jack