Specifications

Live MPEG MAX CSE Encoder Service
54
Vision
2
Operation/Reference Guide
3. In the Username text box enter the username used to gain access to the encoder. The default username is
Admin.
4. In the Password text box, enter the password used to gain access to the encoder. The default password is
1988.
5. Click Apply. If you have entered the correct details then the Encoder Settings section will update to the
values configured on your encoder.
Multicast Settings
The multicast settings section of the page shows the multicast settings used for the output video stream from
the encoder. When you enable the stream the MAX encoder starts the encoding process and multicasts video
on the specified IP address and port. Modify these values if you want to use different settings.
The following options are available in the multicast section:
Encoding Settings
The following options are available in the encoding section:
If you enter an incorrect IP address the system will attempt the connection for 10
seconds and then, if unsuccessful, the following message will appear at the bottom of
the page: “The encoder is not responding, the IP address is incorrect or the encoder
is offline.”
If the encoder has different multicast settings to the values in Vision2 then you will be
prompted to click Apply and update the multicast settings. If the encoder is enabled then
you will need to disable it before updating the settings.
FIG. 59 MAX Encoder Multicast Settings
Multicast Settings Options
Protocol Vision2 only supports the UDP multicast protocol. If your encoder is set to the
RTP protocol you will need to change this setting and apply the changes.
Address This is the multicast address of the Encoder output stream.
Port This is the port number used by the Encoder output stream.
TTL This is the multicast TTL setting for the Encoder output stream.
FIG. 60
Encoding Settings