Specifications

Vision2 User Interface
22
Vision
2
Operation/Reference Guide
Loading and Enabling Vision2 Services
The typical steps the user must follow to load and enable Vision2 services are as follows:
1. Select a service
2. Click Load to load the service details. Note once you load a service then you gain a lock on that service.
This lock prevents any other users from modifying settings on this page and interfering with your work.
3. Configure the service by changing the settings to the required values. Note that you must click the Apply
button in each section that you modify to save the changes. If you forget to press Apply then the changes
will be lost.
4. Enable the service by changing the Enable setting from Off to On, in the majority of cases this will enable
a multicast video stream which you can view in the Live Channels > View screen. A watch button will
appear that you click to jump directly to this screen.
Loading a Service and Service Locking
Load a service as follows:
1. Use the select a service drop down to find the service you want to load, this shows a list of all services of
a particular type (in this case Record) in your Vision
2
system which the current user has permissions for.
The Service on Server label indicates which of your Vision
2
servers hosts this service
2. Click Load
Once you have loaded a service then this service is locked to your user account, this prevents two different
users modifying the same service at the same time. No other user can load this service until the user with the
lock loads another service, navigates away from the screen or closes their browser. If another user tries to
access the service, Vision
2
will prevent access and tell them which user account has locked the service. Locks
for all services except Record and Producer will be cleared after a 20 minutes without activity. Record and
Producer service locks are cleared after three hours without activity, these services have a longer timeout
period to allow the user to set up schedules and to do long manual records.
If user has locked a service but has left their machine then the administrator can release the lock using the
following process:
Once a service is enabled then you cannot remove its license from a server.
FIG. 29 Select and Load a Service
FIG. 30 Enabling a Service