Manualshelf

User Guide

ManualsBrandsAMX ManualsOtherKEYPADBUILDER
51525354555657585960
Mio R-1 Configuration Modules
45
KeypadBuilder v2.1
Text Engraving
The engraving information and options are as follows:
Display Option
This display option is for use within the Engraving window. Placing a check in the box activates its
display.
Export to DXF File
KeypadBuilder creates the .DXF file that is applied to a jig in the engraving machine.
Click OK to keep changes and exit the Engraving module; otherwise, click Cancel and lose the changes.
Text Engraving
Button This button name is dictated by the selected device’s firmware and is intended to assist in
navigating the remote device file.
Display If a text item was created for the selected button it is displayed here. The value is established
in the Display Configuration module.
Text This is either the text or icon set to display on the button. If you select Icon in the font selec-
tion, you could use letters to get the associated icon but the Symbols drop down list is a sim-
pler approach.
Symbols The Symbols drop down list is available when you select AMX Icon in the font selection list.
The list is a collection of icons created by AMX. When you select an icon the corresponding
letter is placed in the Text field. If you select more than one icon it will not replace the previous
icon, but rather add it and display all selected icons. Icons can be scaled.
Font Selection A drop down list of fonts supported by KeypadBuilder for use in engraving the buttons. Icons
must be selected to use the Symbols drop down list.
Scale A ratio ranging from 0.5 to 1.5. The larger the ratio, the more area of the button the icon fills.
Note: If your scale is greater than the area of the button that can be engraved, you will receive a warning in
this field and KeypadBuilder will not create the .DXF file.
Update Confirms changes to the button engraving.
Display Option
Show Bounding Box Displays the surface area of the button you can engrave.
Export to DXF File
Export File... Opens the Export DXF File dialog window. This creates the .DXF file neces-
sary for engraving.
Preview... Opens the Engraving Template Preview dialog window. This is a graphic repre-
sentation of the jig used in engraving.