Data Sheet
CONTROL
Advanced Configuration Interface**
USB Mini-B Connector
Power Indicator
Green indicates whether or not the module is powered
on
**This feature will be available upon release of a future firmware update
INDICATORS
Power Indicator
Green indicates whether or not the module is powered
on
DXLink
Transport Layer Throughput (Max)
10.2 Gbps
Twisted Pair Cable Type
Cat5e, Cat6/6e, Cat6A, Cat7 of UTP, SF/UTP, S/FTP,
and F/UTP varieties ***
Twisted Pair Cable Length
Up to 328 ft (100 m)***
*** Cable runs with a minimum specification of ANSI/TIE/EIA 568A-5 and ratings of 250MHz or better may be used with DXLink equipment. However, cable
run topology and environmental influences can affect the overall successful distance capabilities of these runs. For successful deployments up to 100
meters without consideration to outside variables, AMX recommends the use of shielded category cable (STP) or Cat6A (or better) versions of unshielded or
shielded twisted pair (UTP/STP) for DXLink runs. For more details and helpful cabling information, please contact your AMX representative for a copy of the
white paper titled “Cabling for Success with DXLink”. IMPORTANT NOTICE: DXLink twisted pair cable runs for DXLink equipment should only be run within a
common building.
HDMI
Compatible Formats
HDMI, HDCP , DVI
Input Signal Type
HDMI
DVI-D (Single Link With Cable Adapter)
DisplayPort ++ (Input Only, With HDMI Cable Adapter)
Input Connector
HDMI Type A Female
Propagation Delay (Typ)
5 us
Input Voltage (Nominal)
1.0 Vpp Differential
Input Re-clocking (CDR)
Yes
Input Equalization
Yes, Adaptive
Data Rate (Max)
4.95 Gbps / 6.75 Gbps
6.75 Gbps supported when the DXLink HDMI RX Scaler
is in Bypass mode and format is 1080p60 or less
Pixel Clock (Max)
165 MHz / 225 MHz
225 MHz supported when the DXLink HDMI RX Scaler
is in Bypass mode and format is 1080p60 or less
Progressive Resolution Support
480p up to 1920x1200 @ 60 Hz including but not
limited to those resolutions shown in the DXLink
Twisted Pair Transmitters/Receiver Instruction Manual
Interlaced Resolution Support
480i, 576i, 1080i including but not limited to those
resolutions shown in the DXLink Twisted Pair
Transmitters/Receiver Instruction Manual. If input is
interlaced, all scaled outputs will deinterlace video to a
progressive resolution format. If in scaler Bypass mode
interlaced input will pass through
Deep Color Support**
24-bit, 30-bit, 36-bit
30-bit, 36-bit supported when the DXLink HDMI Rx
Scaler is in Bypass mode and format is 1080p60 or less
Color Space Support
RGB 4:4:4
YCbCr 4:4:4 and 4:2:2
(Input signal support for YCbCr 4:4:4 and 4:2:2, output
color-space is converted to RGB 4:4:4)
3D Format Support**
Yes (HDMI Primary Formats)
Frame Packing 1080p up to 24Hz