Specifications

Terminal (Telnet) Commands
58
ICSLan Device Control Boxes
Terminal Commands (Cont.)
Command Description
SET ETHERNET MODE This command sets the current LAN configuration settings per new mode.
Syntax:
SET ETHERNET MODE <newmode>
Values for newmode are:
auto
- or -
10 | 100 full | half
Note: This command requires a reboot to enable new settings.
Examples :
set ethernet mode auto
set ethernet mode 100 full
Note: See GET ETHERNET MODE on page 55.
SET FRIENDLY Set the device’s friendly name for NDP to <name>.
Syntax:
SET FRIENDLY <name>
• Maximum length = 25 characters. If the name entered exceeds 25
characters, it will be truncated.
• The value is stored in non-volatile memory.
• If no value specified, an automatic name consisting of AMX, the product
name, and serial number will be used.
Note: This command requires a reboot to enable new settings.
SET IP Sets the IP configuration of a specified device.
Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask,
and Gateway IP Address.
Note: “DHCP” implies “DHCP with link-local fallback".
Note: For NetLinx Masters, the "Host Name" can only consist of
alphanumeric characters.
• Enter Y (yes) to approve/store the information into the Master.
• Enter N (no) to cancel the operation.
Note: This command requires a reboot to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter
to keep current settings ---
Enter Host Name: MLK_INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and
then Enter: DHCP
Enter Gateway IP: 192.168.21.2
You have entered: Host Name MLK_INSTRUCTOR
Type DHCP
Gateway IP 192.168.21.2
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable
new settings.
Note: EXB Modules can also be set to Static IP or DHCP Mode via the
front panel ID Pushbutton. See the Toggling Between Static and DHCP IP
Addressing section on page 14 for details.
SET LOCATION Sets the location parameter for NDP.
Syntax:
SET LOCATION <location>
• Maximum length = 25 characters. If the name entered exceeds 25
characters, it will be truncated.
Note: This command requires a reboot to enable new settings.