Specifications

Terminal (Telnet) Commands
55
ICSLan Device Control Boxes
Terminal Commands (Cont.)
Command Description
EXIT Exit the telnet session
FACTORYFWIMAGE Reset unit to factory firmware image and reboots the Module.
GET CONFIG Display the current connection settings.
Example:
>get config
Device number: 10001
Connection Settings
--------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
IP Settings
--------------------------------
HostName: localhost
Type: DHCP
IP Address: 192.168.1.53
Subnet Mask: 255.255.255.0
Gateway IP: 192.168.1.1
MAC Address: 00:60:9f:94:2d:4f
DNS Servers
--------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.20.7
Entry 2: 192.168.20.9
Note: The system number and IP addressing information displayed is
reflective of actual operating values, not stored parameters.
GET CONNECTION Show the Module connection information.
Example:
>get connection
Connection Settings
------------------------------
ICSNet/Ethernet: Ethernet
Mode: URL/TCP
System Number: 1
Master IP/URL: 192.168.1.211
Master Port: 1319
Username:
Password:
GET DEVICE Display the device number.
GET DNS Get list of DNS entries.
Example:
>get dns
DNS Servers
-------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.20.7
Entry 2: 192.168.20.9
Note: When the module is in DHCP mode, these are active values, NOT
the stored values that only apply to static mode.
GET ETHERNET MODE Display the current LAN configuration setting.
Settings are either "auto" in which the LAN driver will discover it's settings
based on the network it is connected to OR <speed> and <duplex> where
speed is either 10 or 100 and duplex is either full or half.
Example:
>GET ETHERNET MODE
Ethernet mode is auto.
Note: See SET ETHERNET MODE (page 58).
GET FRIENDLY <name> Displays the Module’s friendly name (for NDP).