Specifications

Audio/Video Configuration
55
Enova DVX-2100HD 6x2 All-in-One Presentation Switcher Operation/Reference Guide
8 - Microphone (L/R): There are two separate sections for configuring Mic 1 and Mic 2. If you select Single
Stereo for the Microphone Mode, Mic 1 settings affect both Mic 1 and Mic 2 inputs and the section for Mic 2 is
disabled. Selecting Dual Mono activates the Mic 2 section, which contains identical options as the section for
Mic 1. You can set the following options for each microphone:
PreAmp Gain: Use the slider to set the preamp gain level for the mic. You can set the PreAmp Gain between
0 and 65 dB in 1 dB steps. Set the PreAmp Gain to 0 for line-level inputs. Note: Limiter sensitivity is affected
by the Preamp Vol setting, but not by the Gain setting. Increasing Preamp Vol will cause the limiter to activate
at a lower input threshold - Decreasing Preamp Vol will cause the limiter to activate at a higher input
threshold. After adjusting Preamp Vol to set the Limiter sensitivity, use the Gain setting to achieve the desired
overall input gain.
Gain: Use the slider to set the input gain level for the mic. You can set the gain between -24 and 24 dB in 1
dB steps.
Bass: Use the slider to set the bass level for the mic. You can set the bass between -20 and 20 dB in 1 dB
steps.
Treble: Use the slider to set the treble level for the mic. You can set the treble between -20 and 20 dB in 1 dB
steps.
9 - UDM Audio Output: Click AMP Out EQ/MIX to feed the amplifier audio mix to the UDM device. Click Line
Out EQ/MIX to feed the line out audio mix to the UDM device.
10 - Amplified Output Equalizer: Use the sliders to set the audio levels for the outgoing signal. You can set
each setting between -20 and 20 dB in 1 dB steps.
11 - Amplified Output Mix Level: Use the sliders to set the amplified output volume levels for the outgoing
audio signal and the two microphones.
12 - Line Level Output Amplifier: Use the sliders to set the audio levels for the line level output. You can set
each setting between -20 and 20 dB in 1 dB steps.
13 - Line Level Output Mix Level: Use the sliders to set the volume levels for the line level output and the two
microphones.
14 - Fixed/Variable: Click the appropriate option button to indicate whether the line level output is fixed or
variable.
15 - Gain: Use the sliders to set the gain level for the line level output. You can set the line level output gain
between -20 and 20 dB in 1 dB steps.
Your audio configuration is not affected by a power loss, restarting the unit, or
upgrading the firmware.