Specifications

Wiring and Device Connections
32
Enova DVX-2100HD 6x2 All-in-One Presentation Switcher Operation/Reference Guide
Example Configuration
The DVX-2100HD is capable of controlling a multitude of combinations of audio and video devices. A typical
configuration may consist of the following components:
 Equipment is installed in a rack located in or near the room. This rack may include the
DVX-2100HD, a PC, two entertainment sources like DVD player or Satellite receiver, and possibly
an audio/video teleconferencing system.
The PC's DVI Video is connected directly to one source input on the DVX-2100HD and its audio to
the corresponding audio input. Composite Video, S-Video, or Component Video from the DVD
player, Satellite receiver, and video conference system are connected to three additional source
inputs on the DVX-2100HD through the use of the appropriate conversion cables. Again, audio
from these sources is connected to the corresponding audio inputs.
Connections for audio and video from two Laptop PCs are routed to a UDM-0102 or a pair of UPX
wallplates, and the CAT5 outputs on the UDM-0102 or wallplates are connected to the UDM inputs
of the DVX-2100HD.
One RGB output with an RGB adapter cable is routed to an AMX touch panel through an
Audio/Video breakout box. One DVI or RGB output drives a local PC monitor near the rack or a
projector. Alternately, the UDM output can be run to the projector and connected to an appropriate
UDM receiver module like the UDM-RX02N.
Both video outputs can independently show any video input at any of the supported resolutions.
Audio/video sources and displays are connected to and controlled by the DVX-2100HD’s RS-232
or IR ports. I/O ports are used for sensor inputs including proximity, occupancy, light, and power
sensors. Relays are used for any relay-controlled devices like lighting, HVAC, or blinds.
FIG. 46 displays a sample configuration using the DVX-2100HD:
FIG. 46 Sample Configuration