Specifications

Wiring and Device Connections

Enova DVX-2100HD 6x2 All-in-One Presentation Switcher Operation/Reference Guide

VIDEO INPUTS (1-4)

The four DVI-I VIDEO INPUT connectors on the rear panel are used to connect source input devices to the

DVX-2100HD (FIG. 39). The DVX-2100HD routes video from connected source input devices to the

connected output devices. The four DVI-I VIDEO INPUT connectors correspond to source select button 1-4

on the front panel.

These numbered inputs correspond to the numbered INPUT SELECT pushbuttons on the front panel.

The following table describes the pinout configuration of the DVI-I VIDEO INPUT connectors:

Each VIDEO INPUT connector supports DVI-D, as well as RGBHV, S-video, Composite, and Component

inputs, using the appropriate conversion cables. Refer to the Cable Details and Pinout Information section on

page 33 for cable details and pinout information for each cable type:

DVI-D Male to DVI-D Male Single-Link Cable section on page 33

DVI-A Male to 5-BNC Male Cable section on page 35

DVI-A Male to Triple RCA Male Cable section on page 36

DVI-A Male to S-Video Male Cable section on page 38

DVI-A Male to HD15 (VGA) Male Adapter section on page 39

FIG. 39 VIDEO INPUT (DVI-I connectors)

The DVI Input connectors on the DVX-2100HD are DVI-I (integrated digital/analog)

connectors. These connectors support both DVI-A (analog) and DVI-D (digital)

inputs.

DVI-I Input Ports - Pinouts and Signals

Pin Signal Pin Signal Pin Signal

1 TMDS Data2- 9 TMDS Data1- 17 TMDS Data0-

2 TMDS Data2+ 10 TMDS Data1+ 18 TMDSData0+

3 TMDS Data2/4 Shield 11 TMDS Data1/3 Shield 19 TMDS Data0/5 Shield

4 n/c 12 n/c 20 n/c

5 n/c 13 n/c 21 n/c

6 DDC Clock [SCL] 14 +5 V Power 22 TMDS Clock Shield

7 DDC Data [SDA] 15 Ground (for +5 V) 23 TMDS Clock +

8 Analog vertical sync 16 Hot Plug Detect 24 TMDS Clock -

C1 Analog Red

C2 Analog Green

C3 Analog Blue

C4 Analog Horizontal Sync

C5 Analog Ground

If a DVI source is attached before setting the input to DVI, you may need to reboot

the source for it to recognize the DVI input description information required by the

DVI standard.