Instruction manual

DXLink Fiber Specifications
36
Instruction Manual – DXLink Fiber Transmitters and Receivers
* Interlaced video is supported into the Transmitter; progressive is only supported out of the Receiver unless in Scaler
Bypass Mode.
AMX reserves the right to modify its products and their specifications without notice.
Analog Video Specifications
DXLink Fiber TX
Compatible Formats • RGBHV, RGBS, RGsB
• Y/Pb/Pr (HDTV)
• Y/C (S-Video), C (Composite)
Progressive Resolution Support 480p up to 1920x1200 @ 60 Hz (supported resolutions are shown in the
“Supported Input Resolutions” appendix; see page 130)
Interlaced Resolution Support* 480i, 576i, 1080i (supported resolutions are shown in the “Supported Input
Resolutions” appendix; see page 130)
Auto-Adjust Input Supported
RGB Input Signal Level Range 1 Vpp nominal
RGB Input Impedance 75 Ω
HV Sync Input Signal Level Range 2 to 5 Vpp
HV Sync Input Impedance 2.5 pF typical, 10 pF max.
Digital Processing 24 bit, 165 MHz
Y/Pb/Pr Input Signal Level Range • 1.0 Vpp for Y
• 700 mVpp for Pb, Pr
Y/Pb/Pr Input Impedance 75 Ω
Y/C (S-Video) Input Signal Level Range • 1.0 Vpp for Y
• 1.0 Vpp for C
Y/C (S-Video) Input Impedance 75 Ω
C (Composite) Input Signal Level Range 1.0 Vpp
C (Composite) Input Impedance 75 Ω
Input Connector HD-15 (breakout cable required for non-RGB formats)