Instruction manual

Appendix B – Telnet (Terminal) Commands
96
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Telnet Commands (continued)
audio
Note: This command
must be entered in lower
case only.
Note: This command applies only to the Receiver.
Shows audio signal status.
Example:
>audio
--------------------------------
Audio Output
============
Analog Audio ON
HDMI Audio ON
Audio Mute OFF
Audio Input
============
N Value
--------
0x00 0x17 0xFF
Channel Status Bits
-------------------
Audio Type: LPCM
Dolby TrueHD/DTS Master: No
Sampling Freq: 44.1kHz
Channel: 0
Raw Data:
0x00 0x00 0x00 0x30 0x73
Audio InfoFrames
-------------------
Channel: 2
Raw Data:
0x84 0x00 0x00 0x7C 0x01 0x00 0x00 0x00 0x00
0x00 0x00 0x00 0x00 0x00
avi
Note: This command
must be entered in lower
case only.
Note: This command applies only to the Receiver.
Shows AVI InfoFrame status.
Example:
>avi
--------------------------------
Decoder
AVI InfoFrame:
0x82 0x02 0x0D 0x65 0x00 0x08 0x00 0x02 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00
Packet Type: 0x82
Version Type: 0x02
Length: 0x0D
Checksum: 0x65 (Valid)
Color Space: RGB
Colorimetry: No Data
VIC: 2
Pixel Repetition: 1x
CLEAR MASTER
USERNAME
Clears the Master username.
CLEAR USB STATS Note: This command applies only to the Transmitter.
Clears the USB statistics.
DATE Displays the current date.