Instruction manual

DXLink Fiber Specifications
29
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Compatibility Note: In Enova DGX systems using duplex fiber technology – the DXLink Fiber Input Board
and its DXLink Fiber TX, Duplex must have the same type of fiber optic transceiver: either multimode or single
mode. The same holds true for DXLink Fiber Output Boards and the DXLink Fiber RX, Duplex units.
Note: A list of HID devices which have been tested and found to be working well with the latest firmware is
available (see “DXLink - HID supported Devices” on the DXLink Fiber Receiver’s product page).
AMX reserves the right to modify its products and their specifications without notice.
General Specifications (continued)
Noise Level 0 dBA @1m (typical), 45.3 dBA @ 1m (max)
Airflow Convection (openings on top of case, typical); forced air (out of front plate, when
fan is active).
Approvals UL 60950-1, CSA 60950-1, IEC 60950-1, CE EN 60950-1, CE EN 55022
Class A, CE EN 55024, FCC CFR Title 47 Part 15 Subpart B Class A, ICES-003
Class A, RoHS, WEEE
Other AMX Equipment
AMX Products Compatible with
DXLink Fiber Transmitters, Duplex
Enova DGX Digital Media Switchers
AMX Products Compatible with
DXLink Fiber Receivers, Duplex
Enova DGX Digital Media Switchers
Included Accessories • Desktop power supply (ENERGY STAR
®
qualified): 1 per unit
Caution: Only the provided desktop power supply should be used, and it
must not
be altered in any way.
Compatible / Optional Equipment • CC-NIRC, NetLinx Emitter Cable (FG10-000-11)
• IR03, External IR Receiver Module (FG-IR03)
• CC-MINIUSB, Mini USB to PC cable adapter (FG5967-20): use with DXLink
Fiber RX only – for connecting a keyboard/mouse device
• CC-USB, USB programming cable (FG10-5965): use with DXLink Fiber TX
only – for connecting to a PC
NetLinx and Control Specifications
ICS LAN / Ethernet Port • TCP/IP port (ICS LAN 10/100)
• RJ-45 connector
Serial Port • Bidirectional RS-232
• Standard NetLinx baud rate 1200 to 115k
• Parity support: Odd/Even/None
• 3.5 mm pluggable Phoenix terminal block
IR Control Port • Port for use with IR03 External IR Receiver (optional accessory FG-IR03)
• Port for use with CC-NIRC NetLinx Emitter (optional accessory FG10-000-11)
Advanced Configuration Interface USB mini-B connector (Program port)
ID Pushbutton • Toggle between DHCP and static IP addressing
• Places system in NetLinx Device ID assignment mode
• Reset the factory default settings
• Restore the factory firmware image
USB (HID) Keyboard and Mouse Specifications
USB (HID) TX • (1) USB mini-A/B connector (“Host”)
• Connect a DXLink Fiber TX to a PC and emulate keyboard and mouse
commands from a DXLink Fiber Receiver or a DXLink Twisted Pair Receiver
USB (HID) RX • (1) USB mini-A/B connector (“Device”)
• Connect a keyboard and mouse and send commands to a PC connected to a
DXLink Fiber Transmitter or a DXLink Twisted Pair Transmitter