Instruction manual

Appendix C – Virtual NetLinx Master
115
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
7. At the prompt (>), type SET DEVICE <num> and press Enter.
For the <num> value, the valid range of device numbers is 0 to 31999.
Setting a device number does not require a reboot to take effect.
8. At the prompt, type SET CONNECTION and press Enter.
9. Specify TCP for the connection and the PC’s static IP address for the Master.
The Transmitter or Receiver displays under the Virtual Master and is now ready for file transfers.
Note: The process can be repeated for additional Transmitters and Receivers.
File transfers via a Virtual Master:
IRL file transfers, see page 61
Firmware file transfers, see page 89
Important: Once you have finished using the Virtual Master – if you disabled a network connection before
setting the PC’s static IP address, be sure to disable the Virtual Master’s network connection and enable the
original connection.