Instruction manual

Appendix B – Telnet (Terminal) Commands
105
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Telnet Commands (continued)
SHOW DIGITAL STATS Note: This command applies only to the Transmitter.
Displays information about the digital signal.
Example:
>show digital stats
Transmitter Video Signal
Video mode: HDMI
Upstream video is not freerun.
Is not 3D
1920 x 1200 5994 (Hz*100)
PClk: 15399 (MHz/10000) HFreq: 7403 (Hz*100), VIC: 0
HBlank: 48+33+79=160 HTotal: 2080
VBlank: 6+12+52=35 VTotal: 1235
Interlaced: False
Replication Factor: 1
Deep Color: 8 bits
Color Space: RGB 444
Video is not encrypted.
SHOW DNS Shows the DNS settings.
Example:
>show dns
DNS Servers
------------------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
SHOW LOG Displays the message log.
Syntax:
SHOW LOG <start>
• Use <start> to specify the message number to start displaying.
• Use <all> to display all messages.
SHOW MASTER
CONNECTION URL
Shows Master connection information.
Example:
>show master connection url
Master Connection URL
------------------------------------------
Master IP/URL: 192.168.1.91
Master Port: 1319
SHOW NDP INFO Displays NDP information.
Example:
>show ndp info
Stored Parameters:
Master Connection Mode : NDP
MAC Address for bound Master : 00:60:9f:94:94:1f
Current Parameters:
Current NDP state is : NdpFound
Number of announcements : 2
Current Master IP Address : 192.168.43.52
SHOW ROUTE Shows all active network routes the device detects.
Example:
>show route
Active Routes
------------------------------------------
Network Netmask Gateway
0.0.0.0 0.0.0.0 192.168.43.2
127.0.0.0 255.0.0.0 127.0.0.1
192.168.43.0 255.255.255.0 127.0.0.1