Instruction manual

Programming
79
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Standby Mode
Standby Mode can be activated via channel 100 on the DVX. The following points apply to Standby Mode on the DVX:
After exiting Standby Mode, the DVX cannot re-enter Standby Mode for a period of 20 seconds. Any attempt
to re-enter standby mode within this 20 second window is ignored.
When the DVX enters Standby Mode, all video and audio circuitry are turned off. The DVX does not produce
a video or audio output signal in low power state.
The 5002 Device stays online when Standby Mode is active.
All switch and configuration commands sent while in Standby Mode are implemented, and any changes will
be noticed after the DVX exits Standby Mode.
All audio and video signals are restored in less than 10 seconds after exiting Standby Mode.
The DVX exits Standby Mode on any power cycle or reboot.