Instruction manual

Audio/Video Configuration

Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual

System Settings

FIG. 67 displays the System page. The System page allows you to switch any audio or video input to any output, set the

front panel button lockout, adjust front panel LED and LCD intensity, and view the device information for the switcher.

FIG. 67 WebConsole Configuration page - System page

1 - Input/Output Matrix: Select an option button under each output to switch video or audio from the corresponding input

to that particular output. Green text indicates a signal is detected, gray indicates a signal is detected but cannot be

identified, and red indicates no signal is detected. You can only select one video and audio input at a time per output.

Select None if you do not want any video or audio on the selected output.

2 - Save/Load: Click the buttons to save or load your DVX settings. Files are saved as an .xdv file to any local or network

drive of your specification.

Note: Due to the way many browsers manage file upload requests while in an authenticated session, it is not possible to

load a DVX setup (.xdv) file with any web browser AMX has tested, except Microsoft Internet Explorer when HTTP

Security is enabled on the DVX Master.

3 - Microphone Mode: Click the checkboxes to activate or deactivate the microphones connected to Mic Inputs 1 and 2

when in Dual Mode, or the L/R Microphone when in Single Stereo Mode.

4 - Front Panel Lockout Mode: Click the check box to activate a lockout of some or all of the buttons on the front panel.

Select the type of lockout in the Lockout Mode section. Select Full Lockout if you want the lockout to block the use of all

front panel buttons. Select Menu-only Lockout if you want the lockout to only block the use of the menu options on the

front panel. The Switch, Take, Status, Volume, and Mute buttons are still available with this option.

5 - Front Panel Backlight: Use the sliders to adjust the backlight intensity of the LCD display and the LEDs on front

panel buttons. You can set the backlight intensity for each option between 0 and 100. The default setting for each option

is 50.

6 - DXLink Ethernet: Use the menu to select the DXLink Input or the DXLink Output, then click the Auto check box to

enter Auto mode for the selected input or output. In Auto mode, Ethernet traffic is enabled if the port is connected to an

end-point transmitter or receiver, but is automatically disabled if connected to a port on another Enova DVX or DGX.

When Auto is not checked, Ethernet is turned off for the selected port.

7 - System Information: This area provides the following read-only information about your unit:

Serial number

MAC Address

IP Hostname

IP Address

IP Subnet Mask

IP Gateway

IP DNS Addresses

Switcher Firmware Version

Master Firmware Version

Device Firmware Version

Temperature (ºC)

Temperature Alarm

Fan Speeds (RPMs)

Fan Alarm

Standby Mode