Instruction manual

Audio/Video Configuration
66
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Mixing Microphones onto Analog and HDMI Outputs
Follow these steps to connect and mix audio from a microphone input onto the source audio being routed to an audio
output. The Mic inputs can accept both Microphone level and Line level audio.
1. Connect an audio source to one of the microphone inputs on the DVX.
2. See Using a Web Browser section on page 56 and follow the instructions to open the DVX Web Configuration page.
3. On the Audio In / Microphone tab, select the appropriate Pre-Amp gain setting for the input type you are using (see
item 7 in the Audio In/Microphone section on page 63 for more information):
If the input source connected to the microphone input is a line-level signal, adjust the Pre-Amp Gain for that
microphone input to 0.
If the input source connected to the microphone input is a microphone-level signal, adjust the Pre-Amp Gain
for that microphone to a setting above 0 (typical values are between 20 and 30 dB).
4. If the connected microphone requires phantom power, check the Phantom Power check box for that microphone
input (see item 6 in the Audio In/Microphone section on page 63 for more information).
5. In the same section, turn on the connected microphone by checking the Enable check box for that microphone
input.
6. On the Audio Output tab, select each analog audio output (see item 1 in the Audio Out section on page 61) and
adjust the mix level as desired for each output (see item 10 in the Audio Out section on page 61).
To hear both program audio and microphone audio on an analog output, start by setting the mix sliders for
both the Input and the Mic all the way up and then make minor adjustments to these sliders to achieve the
desired relative audio levels.
To hear only the program audio on an analog output, set the microphone mix levels all the way down (-100)
and the Input mix level all the way up.
To hear only the microphone on an analog output, set the Input mix level all the way down (-100) and the Mic
mix level all the way up.
7. To hear the microphone on an HDMI output, follow the instructions for Mixing Microphones onto Analog and
HDMI Outputs section on page 66 and select an analog output that has been mixed to receive microphone audio in
step 6 above.