Instruction manual

Audio/Video Configuration
65
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Setting Up Surround Audio
To pass surround audio from HDMI inputs to HDMI or S/PDIF outputs you must have an HDMI sink (display, AVR,
etc.) that supports one or more surround formats. Follow these steps to configure the DVX to pass-through surround
audio.
1. Connect a source that is capable of providing surround audio to an HDMI input on the DVX.
2. Connect a sink that supports surround audio to an HDMI output on the DVX.
3. See Using a Web Browser section on page 56 and follow the instructions to open the DVX Web Configuration page.
4. To manually select an audio format to request from the source (switcher firmware 1.4.4 or higher):
On the Audio In tab, select the HDMI Input connected to the source.
Select the desired surround format from the HDMI Audio options menu.
5. To pass an HDMI sink's audio capabilities to the source device:
On the Video In tab, select the HDMI Input connected to the source.
Select Mirror Out x from the EDID Mode options menu where x is the output number connected to the
surround-capable sink (see item 6 in the Video In section on page 60 for more information.)
6. In the HDMI Output section of the Audio Out tab, select the HDMI output that is the destination for surround audio
and then Select Input Pass-Thru from the Audio Source options menu (see item 3 in the Audio Out section on
page 61 for more information).
7. If sending surround audio to the S/PDIF output, select the same HDMI output used in step 6 above in the S/PDIF
Output Audio Source options menu (see item 4 in the Audio Out section on page 61 for more information).
8. Route the video from the HDMI input connected to the surround audio source to the HDMI output selected in step
6 above.
Follow these same steps when receiving surround audio from a DXLink input and/or sending audio to DXLink outputs.
Connect all DXLink transmitters/receivers to the DVX, connect sources and sinks to DXLink transmitters/receivers, and
select the appropriate DXLink input/output on the DVX in the steps above.
Embedding Audio on an HDMI Output
Follow these steps to configure an HDMI, DXLink or S/PDIF output to embed audio from a stereo source:
1. Connect either a digital audio source on an HDMI input or an analog audio source on one of the analog audio
inputs.
2. Connect an HDMI sink (display, AVR, etc.) that can accept audio over HDMI.
3. See Using a Web Browser section on page 56 and follow the instructions to open the DVX Web Configuration page.
4. In the HDMI Output section of the Audio Out tab, select the HDMI output that is the destination for audio and then
select the analog output you want to embed from the Audio Source options menu. (See item 3 on Audio Out section
on page 61 for more information).
5. Route the desired input audio (connected in step 2) to the analog output chosen in step 4, and it will automatically
embed on the selected HDMI and/or S/PDIF output.
6. In the HDMI Output section, select the Apply EQ check box if you want the audio on the HDMI output to be
affected by the DVX's Volume and Equalizer settings. De-select this box if you want un-equalized, unity gain audio
on the HDMI output (recommended if adjusting volume and EQ at the downstream HDMI sink).
7. To send the same analog audio to the S/PDIF output, select the same Analog output used in step 4 above in the
S/PDIF Output Audio Source options menu (see item 4 in the Audio Out section on page 61 for more
information).