Instruction manual

Installation
11
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Installation
Overview
This chapter provides information on installing a DVX into an equipment rack.
Mounting the DVX into an Equipment Rack
The DVX occupies three rack units in a standard equipment rack. The following steps apply to mounting the DVX.
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Position and install the mounting brackets, as shown in FIG. 1, using the supplied mounting screws.
Note: The left and right mounting brackets are not identical. Please install in the orientation shown.
FIG. 1 displays how the brackets should be attached to the DVX:
FIG. 1 Rack mounting the DVX
3. Install the DVX in the mounting rack by using the mounting screws to affix the unit to the rack.
4. Connect any applicable wires to the DVX. Refer to the Wiring and Device Connections section on page 13 for
wiring diagrams and pinout descriptions.
WARNING! DO NOT stand other units directly on top of the DVX when it is rack mounted, as this will place excessive
strain on the mounting brackets.
Brackets attach at the side
toward the front of the unit