User`s guide

KwikNet System Configuration
K
A
DAK
97
PPP IP Address Definition (continued)
Edit: IP Address
You must select the Edit: IP Address radio button to define the network's IP address and
related parameters.
IP Version
Select the combination of IPv4 and IPv6 protocols that this network interface supports.
IPv4 Support only IPv4.
IPv6 Support only IPv6.
All (v4 and v6) Both IPv4 and IPv6 must be supported.
If you select IPv6, be sure to configure your KwikNet Library to include IPv6 support. To
do so, check the box labeled "Support IPv6" on the IPv6 property page. Failure to do so
will result in a compilation error when you attempt to compile your KwikNet Library. The
error will inform you that your library does not include support for IPv6.
Packet Forwarding
Select the type of packet forwarding that this network interface supports.
Disabled Forwarding of packets is not allowed on this interface.
Unicast only Support forwarding of IPv4 or IPv6 unicast packets.
Unicast + Dir. Broadcast Support forwarding of IPv4 or IPv6 unicast packets
and IPv4 directed broadcast packets.
IP Address
Enter the IP address of the network interface. This must be a unique, valid IP address
which can be used to identify the host computer attached to this network interface. Enter
0.0.0.0 if the network IP address is to be assigned or negotiated at runtime.
Remote IP Address
Enter the proposed IP address for the foreign host to which the PPP network interface is
to be connected. If an address is provided, the network driver will attempt to negotiate
with the peer to establish the specified address as the peer's IP address. If the negotiation
fails, the network will accept the address provided by the peer. Enter 0.0.0.0 if the
proposed remote IP address is to be assigned at runtime or if there is no desire to propose
an IP address for use by the peer.