Installation guide

TIBCO ActiveMatrix BPM Installation and Configuration
Determine the Architecture for Your System
|
21
Basic System
A basic system consists of a simple installation with all the components installed
on a single machine that can be used for validation purposes. This type of setup is
not suitable nor recommended for production purposes. However, you can use
this for testing or demonstration purposes. Installing the Product describes how
to install a basic system.
Highly Available and Fault Tolerant System
In the event of a hardware failure resulting in the failure of TIBCO ActiveMatrix
BPM, a highly available, fault tolerant system starts TIBCO ActiveMatrix BPM on
another machine, thus ensuring limited service interruption and no loss of data or
messages.
This is achieved by configuring TIBCO ActiveMatrix BPM using either:
A third party solution such as Microsoft Cluster, HP ServiceGuard, or Oracle
RAC, or
Active-active clustering.
Setting up the advanced architectures may involve repeating one or many of the
steps of setting up a basic system along with some additional configurations.