Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 87
Kaleidescape Installation Guide System Configuration
1. Select all the types of outputs that the display supports by checking the
checkboxes.
2. Select native video modes for the displays from the drop-down menus.
The native mode refers to the number of pixels in the display resolution.
3. Select Primary video output from the drop-down menu.
4. Select the video mode for each format from the drop-down menus. The
video mode can be selected automatically or can be specified. When
automatic is selected, the system selects based on the capabilities
selected above. Specifying a mode is usually recommended.
5. Configure the letterbox display. Click the applicable radio button.
6. Select black level for component video. Click the applicable radio button.
7. Cli ck
OK to save settings.
Audio Settings for the Movie Player and Movie Player 2
(KPLAYER-2000, KPLAYER-2500, KPLAYER-5000)
See Audio Settings for the Mini System and 1080p Player on page 84.
Language Settings
A preferred language for movie playback can be configured for each player.
1. Select the
LANGUAGE tab, then select the Preferred Language from the
drop-down menu. See Figure 4-16.
Figure 4-16 LANGUAGE Tab Settings
If NONE is selected, movies play in the original language.
If a language is selected, movies from a country that speaks the
preferred language are played with the original soundtrack without
subtitles.
2. For movies from countries that do not speak the preferred language,
select whether or not to see subtitles or hear a soundtrack dubbed in