Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 60
Kaleidescape Installation Guide Physical Installation
1. Pull down the front panel.
2. Align the disk cartridge to the slot. The status light goes towards the top.
3. Pull the latch down on the disk cartridge.
4. With the latch down, slide the disk cartridge in as far as possible, just
until the latch starts to close.
5. Close the latch completely and push on the label above the status light
until the disk cartridge is firmly seated.
6. Verify that all disk cartridges are evenly aligned and status lights glow
blue before closing the front panel.
If the latch is closed before inserting the disk cartridge, the
disk cartridge cannot be seated properly and the drive can
be damaged.