Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 58
Kaleidescape Installation Guide Physical Installation
Figure 3-14 Disk Cartridge Latch
3. Align the disk cartridge to the slot.
3U Server – Latch goes to the top with lights at the bottom.
1U Server – Latch goes to the left with lights to the right.
4. Insert the disk cartridge into the open slot. Push firmly but gently until
the disk cartridge clicks into place. Do NOT slam the disk cartridge.
5. Verify that the disk cartridge status light glows blue.
Note: If replacing a single failed drive on a 3U Server, the newly installed disk
cartridge becomes the new hot spare. The blue status light on the hot
spare disk cartridge blinks at two second intervals.
Adding a disk cartridge
to a 3U Server
Adding a disk cartridge
to a 1U Server