Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 51
Kaleidescape Installation Guide Physical Installation
If mounting to drywall (hollow wall), or masonry (solid wall), drill a
3/16 in. (5 mm) hole for the screw anchors. Insert the anchors and tap
with a hammer until anchors are flush with the surface. Tighten each
screw additional turns, refer to Table 3-3 on page 50.
3. Align the player mounting slots to the bracket pegs and slide the player
down until the player clicks into place.
Power Supply Mounting
Use the following procedure to mount the M300 Player power supply.
1. Follow the steps in Site Preparation on page 46 using the power supply
bracket as a template.
2. Place the power supply inside the bracket with the label facing away
from the wall.
3/16 in. hole for anchor
or 3/32 pilot hole
Screw anchor for
drywall or masonry