Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 48
Kaleidescape Installation Guide Physical Installation
5. Prepare mounting holes. Place the bracket or bracket template against
the wall and mark the locations of the four holes.
6. Drill holes for fasteners. If the surface is wood or a similar material, drill
a 3/32 in. (2 mm) pilot hole at each location.
7. Check that the mounting screws are the appropriate length. Do not use
the screw anchors for wood.
a. If mounting on drywall (hollow wall) or masonry (solid wall), drill a
3/16 in. (5 mm) hole for the screw anchors. Insert the anchors and
tap with a hammer until anchors are flush with the surface.
b. If mounting the power supply with the player, repeat steps for the
power supply bracket.
8. The player serial number is not visible after the player is mounted.
Attach the extra serial number label (included in the packing box) to an
area where the number can be read.
Permanent Mounting
Use the following procedure to mount the M300 Player permanently.
1. Use a #1 Phillips screwdriver to remove the screw located on the bottom
of the player.
2. Align mounting slots on the bottom of the player to bracket pegs.
Invert bracket for mounting
orientation with connectors up
Mounting slots
Bottom screw