Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 46
Kaleidescape Installation Guide Physical Installation
5. Press the side panel tabs into the slots.
6. Slide panel forward until the panel locks into place and is flush with the
back of the player.
7. Repeat for right side panel, number 502-1003.
Note: Panels are purely cosmetic. If space is a consideration, panels can be left
off.
Wall Mounting the M300 Player
The M300 Player ships with a bracket for mounting the player to a vertical
surface and a bracket for mounting the power supply.
The M300 Player can be mounted two ways.
• Permanently to a wall with bracket screwed to the player
• Without a screw in the bracket so the player can be easily removed
Note: Mounting the M300 Player vertically can interfere with receiving IR
commands by the IR receiver on the front of the player (just below the front
panel). The
IR-IN port on the back of the player can be used to connect the
player to a remote IR receiver, an RF gateway, or a control system. See
Connecting Components to the Network on page 34.
Site Preparation
Use the following procedure to prepare the mounting site.
1. Plan the location. Consider orientation, cable lengths, and ventilation as
well as local building and electrical codes.
The M300 Player can be mounted with connectors up or down. The
shape of the bracket fits the shape of the player.