Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 45
Kaleidescape Installation Guide Physical Installation
Standby mode allows other components in the system to access the
content on the Mini System and music zones 2 and 3 remain
operational. However, while in standby, zone 1 cannot be used for
movies or music.
To power off the Mini System, press and hold the
POWER button for
10 seconds. The disk cartridge lights turn off.
Note: In case of power failure, when power is reinstated, the Mini System returns
to the same state as when the power failure occurred.
Tabletop Installation for the M500 Player
The M500 Player is packaged with rack ears. Tabletop installation involves
removing the rack ears and installing side panels.
1. Remove the four screws that fasten each of the rack ears to the player.
Use a #2 Phillips screwdriver.
2. Identify the left side panel (as viewed from the front of the player). The
number 502-1005 can be found in the middle of the inside of the left
side panel.
3. Position the side panel tab to back, finger guide to front.
4. Align the six plastic tabs on the panel with the six slots on the left side of
the player.