Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 44
Kaleidescape Installation Guide Physical Installation
2. Press the POWER button on the front of the player. The front panel glows
blue.
Mini System
1. Plug the power cord into the socket labeled AC-IN on the back of the Mini
System. Plug the other end of the cable into a grounded outlet with a
high-quality surge protector.
2. To power on with the power button, pull down the front panel and press
the
POWER button located to the right of the disk cartridges. Wait
30 seconds for the system to power on and disk cartridge status lights
to go on.
After initial power on, pushing the
POWER button toggles the Mini System
in and out of standby mode. (Standby mode leaves the
POWER button
pulsing and the other button lights off. Disk cartridge status lights
remain on.)
Power can be applied three ways.
• Using the Kaleidescape Mini System remote control
• By the power button located under the front panel
• Via the control protocol (RS-232 serial or TCP/IP commands
(ENTER_STANDBY, LEAVE_STANDBY))