Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 37
Kaleidescape Installation Guide Physical Installation
M300 Player
1. Plug an Ethernet cable into the port labeled NETWORK on the back of the
player.
2. Plug the other end of the Ethernet cable into an Ethernet switch. A
Gigabit switch is strongly recommended, and required if more than one
player is used to watch Blu-ray movies at the same time.
The left light indicates connection speed. When a 1000Base-T link is
established, this light is amber. When a 100Base-TX link, this light is
green. The right light blinks green when there is Ethernet activity.
3. Connect appropriate A/V cables. Refer to Table 3-2 for cable restrictions.
4. Connect IR controller cable if required. See M500 IR cabling instructions
above. No additional cabling is required for Ethernet (TCP/IP) controllers
if the controller is part of the network.
Music Player
1. Plug an Ethernet cable into the port labeled NETWORK on the back of the
player.
The left light indicates activity and lights orange. The right light blinks
amber when there is Ethernet activity.
2. Plug the other end of the Ethernet cable into an Ethernet switch.