Installation guide

Kaleidescape Part No. 101-0105-00 Rev 3 Page 160
Kaleidescape Installation Guide Network Requirements
Kaleidescape components, go to the COMPONENTS tab of the browser
interface at http://my-kaleidescape/installer/components.html.
Resetting an M-Class Player to Use a DHCP Address
To remove a static IP configuration on an M-Class player, press the network
RESET button on the back of the player to return the player to the factory
default DHCP setting. The network
RESET button is located just left of the
analog audio connectors. (For non-M-Class players, the configuration must
be changed on the browser interface
NETWORK settings.)
To activate the
RESET button, insert a paperclip in the reset hole. Press until
the indicator on the right side of the Network connector starts blinking, then
release. The player restarts with the factory default DHCP setting.
Assigning Static Network Addresses
If the installation site does not have a DHCP server, or if DHCP cannot be
used for Kaleidescape components, IP addresses can be assigned
manually. See Network Settings on page 88. Add a DHCP server temporarily
to the site network to access the installer pages of the browser interface and
enter IP settings that are valid for the local site network.