User Guide

Using the DXP-PRO Wizard

XP-PRO v1.1 - Programmer’s Guide

Selecting a G4CC Source Type only configures the DXP-PRO application to be enabled to function

with G4CC-enabled touch panels. To configure:

1. From the System Information dialog, click the Add button to add a device to the list via the

Device Configuration dialog page.

2. From the Source Type field of the Device Data tab, click the Source Type down-arrow to open

a drop-down list of available device types.

3. Select G4 Computer Control. Once selected, the Display name is greyed-out and reads

G4CC.

4. Click OK to enter the information and return to the System Information dialog page. For

further detailed information regarding the use of the G4CC USB stick, visit the www.amx.com

website.

How to configure i!-Weather

If the i!-Weather application is installed on a Master without a weather account, only AMX-related

locations are viewable within the i!-Weather setup page on the touch panel. To gain access to any

zip code's weather information, you must purchase a subscription from AMX.

To obtain this subscription, all you need is the serial number of your target Master. This appears on

the i!-Weather page on the panel (once the project is loaded). Another method of obtaining the

Master's serial number is by going into a Terminal session and typing 'show device'.

To configure:

1. From the System Information dialog, click the Add button to add a device to the list via the

Device Configuration dialog page.

2. From the Source Type field of the Device Data tab, click the Source Type down-arrow to open

a drop-down list of available device types.

3. Select i!-Weather. Once selected, the Display name is greyed-out and reads Weather.

4. From within the i!-Weather Data section, select from among the three different types of

available weather data (temperature, wind speed, and pressure).

5. Click OK to enter the information and return to the System Information dialog page.

When using G4 Computer Control, it is important to understand that DXP-PRO does

not setup the USB stick applications for you. It is necessary to configure the

corresponding configCC and amxCC application information fields (regarding the

Master and touch panels) prior to compiling the DXP-PRO project. Any Master code

alterations and configCC field entries must be done prior to launching the amxCC

executable.

If TakeNote was selected in the wizard, by default, TakeNote becomes enabled within

the G4CC panel page even before it is selected. To disable TakeNote, you must

navigate to the G4CC touch panel page, press the TakeNote Controls button, toggle

the Activate Annotation button (from within the TakeNote popup menu) to the Off

state, and press the Close button. To re-establish the TakeNote feature, return to the

TakeNote popup menu, toggle the Activate Annotation button back to the On state,

and press the Close button.