User Guide

Using the DXP-PRO Wizard

DXP-PRO v1.1 - Programmer’s Guide

 Control Logic: Select a Control Logic option from this drop-down list, if applicable.

 The IR Data section allows you to configure a number of settings for IR controlled

devices. The IR File field displays the currently selected IR file (read-only). You can

select an IR file using the Browse button or the Search button.

 Search button (binoculars): Brings up the Search for IR File dialog, which allows

you to search by Manufacturer, Hand Control Model # or Device Model #.

Once an IR file has been selected the information about the IR file is extracted and is

displayed in the text fields below the IR File area (at the bottom of the Search for IR Files

dialog).

 IR File: Use the Browse and/or Search buttons to locate and select the IR file to be

associated with this IR-controlled device. All options in the IR Data section of this

tab are disabled if Serial or IP were selected as the Control Method.

 Manufacturer, Hand Control Model #, Device Model #, Info: These read-only

fields are populated with information, once an IR file has been associated with this

device. When any IR-controlled device is selected, three additional tabs become

available on Device Configuration dialog (IR Mapping, Control Configuration, and

Power Control).

 The Serial Data section allows you to select the Baud Rate from a combo box. This

section will only be active when Serial is selected as the Control Method. The Power

Control tab appears depending on whether the device's control specification supports

power control.

 Click the down-arrow to open a drop-down list of all supported baud rates for

Serial (RS-232) control.

 Click to select the appropriate baud rate for the Serial-controlled device. This field is

only enabled if Serial was selected as the Control Method, and the baud rate used in

the Control Method does not have a default setting.

 The IP Data section allows you to enter the IP Address of the device in the IP Address

field. The IP Port number is set within the Control Method and is not accessible. This

field is only enabled if IP was selected as the Control Method.

The only Source Type that enables the AXlink Control Method are Cameras.

If either a Camera or Video Display (such as a Projector/Plasma and TV) are chosen

to be controlled via Serial (RS-232), two new fields become available within the

Device Data section. Place a checkmark in the Use remote serial interface field to

indicate you are using an external serial interface or leave it unchecked to use a

Serial port on the Master. If this option is checked, you can choose which port on the

COM card to use by choosing a port from the drop-down list. This was implemented

to communicate to some cameras and display devices that are not located near the

Master.

If IR is selected, you must locate the associated IRL file by using the Browse or

Search buttons. If you are using Serial as a Control Method, choose the device from

the Control Logic drop-down list.