User Guide

On-SIte Installer Overview

DXP-PRO v1.1 - On-Site Installer’s Guide

Lighting

MAX - Integrated Content Servers by AMX

MAX-MMS and MAX-IMS media servers are supported for G4 touch panels only, via Ethernet

control.

DXP-PRO treats these devices essentially the same as any other Ethernet-controlled device (such as

MP3 players). To add MAX servers to a DXP-PRO project be aware that:

 The MAX-MMS and MAX-IMS servers are controlled only by Ethernet and must be

used with AMX G4 touch panels.

 The MAX-AVM A/V Module(s) connected to a MAX-MMS server must each be set to a

unique zone number (per server).

 Refer to the MAX-MMS and MAX-IMS Installation Guides (available online at

www.amx.com) for details.

•AMX ALD-D48

• AMX Radia

• Clipsal C-Bus Note: The Clipsal C-Bus and Dynalite lighting systems

(DXP-PRO v1.1 or higher) are primarily used outside the U.S.

• DynaLite - Any DTK Series

• Lehigh DX2

• LiteTouch 5000LC

• Lutron GRAFIK Eye

• Lutron Homeworks Interactive

• Lutron RadioRA

• Vantage Qlink

• Tridonic DALI Note: The Tridonic Lighting System type does not have

feedback; therefore, the buttons in DXP will not depress to

reflect feedback.

• Other Ethernet - user supplied/modified light

• Other Serial - user supplied/modified lights.axi

• MAX-MMS MultiMedia Servers (MAX-MMS125/200/300/350/400M/900M)

• MAX-IMS Integrated Music Servers (MAX-IMS500/1000/1500/2500)

If multiple MAX-MMS or MAX-IMS servers are used in a project, each server must

have its own unique IP Address.

An identical IP Address can't be assigned to more than one device, with the exception

of a MAX. A MAX unit can ONLY have an identical IP only if it uses different zones

per display name entry. Ex: A MAX-IMS assigned to IP Address 1.1.1.1 - Zone 1 can

exist in the same project as another MAX-IMS assigned to IP Address 1.1.1.1 -

Zone 2. If you assign to max units with the same IP Address and Output Zone, you

will receive an error message.