Instruction manual

Web-Based Configuration Pages

IS-SPX-1000 & IS-SPX-1300 Inspired Signage XPress Players

Interactivity

The Interactivity tab of the Display Settings page groups several options related to event-triggered interactivity.

FIG. 16 Administration - Display Settings - Interactivity

Administration - Display Settings - Interactivity

Interactivity Settings:

Enable events: Click this box to allow programmed events to be displayed.

Maximum rendering latency: This dropdown menu controls the maximum rendering latency of the display in

milliseconds. Select between 250, 500, 1000, and 1500 milliseconds

Note: increasing the rendering latency number will slow the rendering in the case of

an event.

Reduce latency to 60ms when 

events are received:

To speed performance, click this box to reduce the rendering latency to 60

milliseconds when events are to be received by the display.

Support large number of USB

devices:

Enable / disable the USB software emulation for supporting a greater number of USB

endpoints / devices (when disabled, only 3 USB endpoints are supported).

When mixing full or low-speed devices with high-speed hubs, this option should be

disabled for compatibility. If any problems are encountered while using an interactive

device, try disabling this option to see if that solves the problem.

Apply Press the Apply button to save changes. Pressing this Apply button will not affect any

Touchscreen Calibration changes made on this page.

Touchscreen Calibration:

Coordinate Text Fields If the IS-SPX Player is connected to a touchscreen, the touchscreen display may be

calibrated from this interface. Use the text fields to enter manual coordinates, if

necessary.

Apply Press the Apply button to save any manual changes. Pressing this Apply button will

not affect any other changes made on this page.

Reset to Default Press the Reset to Default button to return the calibration settings to the factory

defaults.

Start Calibration Procedure: If the device is connected to a touch screen, press the Start Calibration Procedure

button and follow the instructions on the touch screen.