instruction manual AXC-INP8 Switch/Opto Voltage Input Card A x c es s C o n t ro l C a rd s
AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: • Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year.
Table of Contents Table of Contents Product Information .................................................................................................1 Input Mode Selections .............................................................................................3 Input Mode Selection Jumpers.......................................................................................... 3 Voltage Mode .........................................................................................................
Table of Contents ii AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card
Product Information Product Information The AXC-INP8 Switch Opto Voltage Input Card provides eight inputs that can respond to switch closures or voltage level (high/low) changes. Input signals may originate from tape transports, limit switches, foot mats, or the AMX PCS Power Current Sensor. Each input may be set for either switch closure (SW) or voltage operation (VO), allowing a combination of either application on the same AXC-INP8 card. Inputs set to the switch mode share the same Axcess system ground.
Product Information 2 AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card
Input Mode Selections Input Mode Selections Input Mode Selection Jumpers FIG. 1 shows the Input Mode selection jumpers. 1 A 2 B 3 4 A B 5 A B A 6 7 8 10 11 B A B A 12 B 13 14 15 A B A 16 B 9 Input 1 Input 2 Input 3 Input 4 Input 5 Input 6 Input 7 Input 8 FIG. 1 Input Mode selection jumpers Voltage Mode Voltage Mode is used to sense high and low voltage states, commonly from AC or DC signals from relay-controlled tape transports and LED feedback from preset dimming systems.
brussels • dallas • los angeles • mexico city • philadelphia • shanghai • singapore • tampa • toronto • york 3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 031-004-2459 6/01 ©2001 AMX Corporation. All rights reserved. AMX, the AMX logo, the building icon, the home icon, and the light bulb icon are all trademarks of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.
