Installation guide
Smart Panel Projector Driver Application Note
Sharp XG-NV6XU
© 1999 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
help@spcontrols.com
undo as in a Windows application, but instead a “return to previous menu” or “back” command.
Menu
can
also be used as
Undo.
Hidden functions are accessed by pressing the indicated key while the holding the
On
key down.
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
UNDO
LENS
TOOLS
KEYSTONE
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the
Smart Panel.
The
Configuration Utility
can
be used to customize these settings your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method
None (see note 1)
Control Wiring Option
Wired Remote (see note 2)
Control for the Sharp with this Driver is via IR/Wired Remote only; we recommend wiring for the Wired
Remote but the included IR emitter may also be used. We
strongly recommend
wiring for RS-232 in
case Sharp remedies stability issues with the RS-232 port.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the
Smart Panel Configuration and Installation
Guide.
Lockout Timer 65 seconds (see note 3)
Inactivity Shutdown Disabled
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A
1B
3A
3B
2A
2B
4A
4B
6A
6B
5A
5B
7A
7B
SELECTION
(EXT. SWITCHER CTRL)
4321
500mA MAX. CURRENT