Manualshelf

user manual

ManualsBrandsAMX ManualsStereo ReceiverCorporation Stereo Receiver HDMI-UTPRO-0808
21222324252627282930
Installation and Setup
26
Instruction Manual – HDMI-UTPRO-0808
System Diagram
The diagram in FIG. 8 illustrates a basic A/V distribution system using an HDMI-UTPRO-0808 Matrix Switcher and
eight HDMI-UTPRO-RX Receivers.
Important: Each HDMI matrix switching output connector must be connected (with HDMI patch cable -
provided) to its corresponding HDMI transport input connector (1 to 1, 2 to 2, etc.).
Rack Installation and System Setup
The HDMI UTPro enclosure can be mounted in a standard EIA 19 in. (48.26 cm) rack. Rack installation ears are
included, and directions for mounting the rack ears are included in the rack installation instructions on page 28.
Important: The system requires at least one empty rack unit above and below the enclosure to allow
adequate airflow; three empty rack units are recommended.
Required items for rack installation:
Enclosure
Standard EIA 19 in. (48.26 cm) rack
 Rack ears with 8 screws per kit
Screwdriver
Screws that fit your rack for mounting the enclosure
Standard US power cord (if shipped within the US)
Optional items for rack installation:
 Surge-protector(s) – highly recommended
A laptop computer or PC with a null modem cable (for communication with the HDMI UTPro via the
Control / RS-232 port)
FIG. 8 System Diagram