Corporation Control System Accessories Operation/Reference Guide

Anterus Configuration Manager

Anterus RFID Solution

This page provides basic information on the entire Anterus System (in the Global Settings row), as well

as for each ANT-RDR connected to the NetLinx Master:

RFID Configuration Manager

•Name Displays the Name assigned to each ANT-RDR. Reader Names can be changed, via the

Reader Configuration page - see the Reader Configuration Pages section on page 24.

Note: The "Global Settings" name cannot be changed.

• Address Displays the device address assigned to each ANT-RDR. Reader Addresses can be

changed, via the Reader Configuration page - see the Reader Configuration

Pages section on page 24.

Note: The "Global Settings" address of zero (0) cannot be changed.

• AxLink Address Displays the AxLink device address assigned to each ANT-RDR, as it was specified on

each ANT-RDR via the 8-position DIP Switch on the rear panel (see the Assigning the

ANT-RDR Device Address section on page 13).

Note: AxLink Device Address does not apply to "Global Settings" (n/a).

•Model Displays the Model name assigned to each ANT-RDR (read-only).

•Errors This column indicates any errors detected by the NetLinx Master, for each ANT-RDR.

These errors are indicated by code numbers.

•Status Indicates the status of each ANT-RDR (Online or Offline).

•Configure • Click the icon in the Global Settings row to access the Global Register page. Use the

options in this page to specify global (system-wide) configuration options, as well as

add and remove RFID Tags from the system. See the Global Register Page section on

page 19 section for details.

• Click the icons in this column to access configuration options for the selected ANT-RDR.

See the Reader Configuration Pages section on page 24 section for details.