User Guide

Standard NetLinx API (SNAPI) R 1.8.0
98
Component Functions: (Cont.)
Name: Channel: Level: Command: Constant: Notes:
setSpaHeat-
State(SOLAR)
180 SPA_SOLAR Momentary Function Channel: Set Spa heat state to solar
setSpaHeat-
State(SOLAR_PREFER
RED)
181 SPA_SOLAR_PREF Momentary Function Channel: Set Spa heat state to solar preferred
setSpaJets(HIGH) 185 SPA_JETS_HI Momentary Function Channel: Set Spa jets to high
setSpaJets(LOW) 183 SPA_JETS_LO Momentary Function Channel: Set Spa jets to low
setSpaJets(MEDIUM) 184 SPA_JETS_MED Momentary Function Channel: Set Spa jets to medium
setSpaJets(OFF) 182 SPA_JETS_OFF Momentary Function Channel: Set Spa jets to off
setSpaLightOn(state) 173 SPA_LIGHT_ON Discrete Function Channel: Spa light is on while channel is active
setSpaPumpOn(state) 171 SPA_PUMP_ON Discrete Function Channel: Spa pump is on while channel is active
setSpaSetpoint(nTem-
perature)
40 SPA_HEAT_LVL Set Spa setpoint, value is in degrees C or F depending on temperature scale
Listener
Name: Pool Spa Listener
Interface: IPoolSpaComponentListener
IPoolSpaComponentListener
Listener Functions:
Name: Channel: Level: Command: Constant: Notes:
processPoolHeat-
StateEvent
175 POOL_HEATER_FB Feedback Channel: Pool heater set to heat state, see state chart
processPoolHeat-
StateEvent
174 POOL_HEAT_OFF_FB Feedback Channel: Pool heater set to off state, see state chart
processPoolHeat-
StateEvent
176 POOL_SOLAR_FB Feedback Channel: Pool heater set to solar state, see state chart
processPoolHeat-
StateEvent
177 POOL_SOLAR_PREF_FB Feedback Channel: Pool heater set to solar preferred state, see state chart
processPoolHeatSta-
tusEvent
187 POOL_HEATING Feedback Channel: Pool heater status is heater, see state chart
processPoolHeatSta-
tusEvent
188 POOL_HEATING_SOLAR Feedback Channel: Pool heater status is solar, see state chart
processPoolLightOn-
Event
172 POOL_LIGHT_FB Feedback Channel: Pool light is on while channel is active
processPoolPumpOn-
Event
170 POOL_PUMP_FB Feedback Channel: Pool pump is on while channel is active
processPoolSet-
pointEvent
39 POOL_HEAT_LVL Pool setpoint changed, value is in degrees C or F depending on temperature scale