Technical information

STEP BY STEP ASSEMBLY

OF THE FMS AND SHUTTLE TRACK

Now position the center piece onto the Slide the master carrier to the end of the

motor pulley, making sure the ball bearing track, against the end pulley.

falls into place, and place the top piece on

the motor pulley again.

On the side of the motor pulley; mark the Take off the return pulley and lift it together

first visible tooth on the opposite part of with the belt up onto the track, like the

the belt where the first master carrier is pictures show.

attached. Remove the motor pulley again

from the track.

On the side of the motor pulley, slide out the Now position the second master carrier over

belt, until the marked tooth becomes visible. the belt connector and slide them together

Now put the belt connector over this tooth. into the track.

it is very important that the marked tooth

is clamped by the connector as shown

in the picture.