Technical information

STEP BY STEP ASSEMBLY

OF THE FMS AND SHUTTLE TRACK

Keep one side of the belt flush with the end of the rail.

Now start counting 17 teeth of the belt, mark the 17th tooth of the belt and cut it here after.

Now connect one end of the belt to the belt Connect the other end of the belt to the

connector and insert the first piece of the connector to make a loop and slide the

master carrier into the track. Make sure the master carrier fully into the track. Again

first tooth stays outside the connector, in the make sure that the first tooth stays outside of

middle. the connector, in the middle.

Now take the FMS motor pulley apart by Position the bottom piece of the motor

removing the screws. pulley onto the track, make sure the belt

falls into place.