Technical information

STEP BY STEP ASSEMBLY

OF THE FMS AND SHUTTLE TRACK

Cut the track 10.5cm shorter than the total Cut the belt under an angle to remove the

lenght required. 1st tooth. This ensures a smooth sliding

Slide the belt through the track by using the through the FMS Return Pulley.

FMS belt connector.

Take off the cord connector and push the Cut off the remaining part of the 1st tooth,

belt through the FMS Return Pulley until then attach the belt connector and put the

the above figure is achieved belt back into the other trackchannel until

above figure is achieved.

Now pull the belt through the track and take

off the belt connector at the end.